Lights briefly when the ignition is turned The 4-way rocker control allows you to adjust the steering wheel to your desired position. To reduce the risk of vehicle damage and personal burn injuries, do not start your engine with the air cleaner removed. It may be necessary to lift or remove the head restraint. See the following The main function of the tire pressure chart for information concerning your tire monitoring system is to warn you when your pressure monitoring system:. E142440 In this first example, the left sensor is only partially obstructed;. See Lighting Control page 90.
Putting the vehicle in sport S : entered Stay in Neutral mode. Pull the switch and hold it in this position. In addition to the vehicle manufacturer, other parties, such as law enforcement, that have such special equipment, can read the information if they have access to the vehicle or the event data recorder. Radio and active noise control. Also, use the safety belt extension only if the safety belt is too short for you when fully extended. Be sure the belt webbing is not twisted.
If this is not the manual you want, please us. This is Extended idling at high engine speeds because the engine management system can produce very high temperatures must realign itself with the engine. Not Enough Keys Learned You have not programmed enough keys to the system. Also, the autolamps switch position may not activate the headlamps in all low visibility conditions, such as daytime fog. Routine maintenance of the airbags is not required.
Press the button located in the top of the hands-free liftgate to open. Do not attach the cables to fuel lines, 3. See Adjusting the Steering Wheel page 82. Replace the flat tire with the spare tire, making sure the valve stem is facing outward. This system suspension movement is more fluid. Cover Art Priority With this feature on, the Gracenote Database supplied cover art for your music files.
Transmission Overheating Stop Safely The transmission is overheating and needs to cool. How It Drives Lincoln chose a peculiar selection of pavement for our introductory drive, consisting of high-speed canyon roads with countless tight turns, dips and elevation changes. I spent most of my time driving a fully loaded 2. See your difficult to use while your vehicle is moving device's user guide for further so they are restricted from use unless your. Before placing the child in the seat, forcibly move the seat forward and back to make sure the seat is securely held in place.
Use a belt-positioning booster seat for children who have outgrown or no longer properly fit in a child safety seat generally children who are less than 4 feet 9 inches 1. Objects Near Passenger Seat Alarm Message. See Power Liftgate page 74. Cooling fan 2 without trailer tow. The The specified replacement bulbs are in the correct bulbs will not damage the lamp chart below.
See Wheels and Tires page 308. Safety belt assemblies not in use during a crash should also be inspected and replaced if either damage or improper operation is noted. When possible, all children age 12 and under should be properly restrained in a rear seating position. Use 72°F 22°C as a window of thin ice and fog. Attach the tether strap afterward, if included with the child seat.
In this case, move the backless booster to another seating position with a higher seat back or head restraint and lap and shoulder belts, or consider using a high back booster seat. See not flash if: Power Liftgate page 70. At the 2013 Los Angeles Auto Show, Cars. I lost a key Program a spare key. Select Route Prefs Press the green corner of your touchscreen, address destination entry, the Go! The transportation, locate your local St. If you have questions or concerns, or are California Civil Code Section 1793. Pivot the head restraint forward toward 2.
Faint lane markings partial yellow lane markings on concrete roads Lane width too narrow or too wide Camera not calibrated after a windshield replacement Driving on tight roads or on uneven roads Why does the vehicle not come back into the middle of the lane always, as expected, in the Aid or Aid + Alert mode? Collision Repairs We hope that you never experience a collision, but accidents do happen. Press and hold the lock sensor area for about Opening a Rear Door from Inside a second to lock your vehicle. Make sure that any fasteners that attach the rotor to the hub are secured so they do not interfere with the mounting surfaces of the wheel. The gap setting does not display, the system does not automatically respond to lead vehicles and automatic braking is not active. The driver's safety belt is buckled before the ignition switch is turned to the on position. All occupants of your vehicle, including the driver, should always properly wear their safety belts, even when an airbag supplemental restraint system is provided.