Thank you so much, every penny helps. Always connect the chains to the frame or hook retainers of the vehicle hitch. Keep all snowplow electrical connections and battery terminals clean and free of corrosion. Fluid Level Check This fluid level can be checked by removing the filler plug. Tire chain use is permitted only on the rear tires of Ram 4X2 trucks. The engine can be started in this range.
This is a normal occur- rence and can be minimized. Squeeze the lock to release the window. Wait approximately 10 seconds, then restart the en- gine. Failure to follow these procedures could result in damage to the charging system of the booster vehicle or the discharged vehicle. Front Fog Light Indicator Light — If Equipped 26.
If not prompted by the Engine Oil Indicator System within 7,500 miles 12 000 km or six months since the last oil and filter change, change the engine oil and engine oil filter. An anchor must be strong enough to hold while winching. Accumulation of snow or ice around the wheels or once the updated tire pressures have been received. Electronically Shifted Transfer Case Only Transfer case position indicator lights are located in the 3. The number will appear in the then dial the corresponding phone number, which display of certain radios. To apply the park brake, firmly push the park brake pedal fully.
This is accomplished by simply moving the shift lever to the desired positions. This will help prevent uneven tire wear. Never add engine coolant antifreeze when the engine is overheated. For maximum delay between cycles, rotate the control knob into the upper end of the delay range. Stow the replaced tire, jack, and have them checked with a torque wrench by your dealer tools as previously described. A slight amount of air is directed through the defrost and side window demister outlets. Allow engine braking to control the descent and apply your brakes if necessary, but do not allow the tires to lock.
Check spare tire for proper pressure and correct stowage. Do not attempt to cross a log with a greater diameter than the running ground clearance or the vehicle will become high centered. Reset will only occur while a resettable function is being displayed. To prevent reducing this extended mainte- nance period, it is important that you use the same engine coolant antifreeze throughout the life of your vehicle. Use this control to regulate the amount of air forced through the system in any mode you select.
Always remove key from the ignition and lock all doors when leaving the vehicle unattended. It could come loose in a collision. Disconnect the remote control cord from the control box and store in a clean and dry place. Return to the vehicle and press the programmed HomeLink button twice holding the button for 2 sec- onds each time. Always apply the parking brake fully when parked to guard against vehicle movement and possible injury or damage. Additional traction for loose, vehicle unattended with the transfer case in the slippery road surfaces only.
When checking oil after operating the The pages that follow contain the required maintenance engine, first ensure the engine is at full operating tem- services determined by the engineers who designed your perature, then wait at least 30 minutes after engine vehicle. To change position inboard or out- board, the mirror head should be rotated flipped Out or In. Operation is subject to the following two conditions: 1. Then, using body pressure, move forward and rearward on the seat to be sure that the seat adjusters have latched. Although the vehicle will display when the fault is initially detected, each will continue to operate while this warning message is time the vehicle is started, and periodically during initially displayed, the engine will not restart the next.
The coupling arm connects to the hitch mounted over the rear axle in the truck bed. If the vehicle is ready for emissions damage to the engine control system. Water In Fuel Indicator stall and your vehicle may require towing. The winch will not power-in or out for 30 seconds if this device is tripped. Be sure the seat is locked in place.