Under the back seat, tried that, in the trunk - tried that. Replacing your starter is not a difficult job at all; you can get it done in less than an hour and be extremely happy with the job you did yourself, as well as the savings that came along with it. Locate the starter on Left Hand drive the starter is on the driver side. Live representatives are always willing to lend a hand with your shopping needs. My battery is good after being tested at Advance Auto 12.
The screws can be accessed by opening the trunk and locating the speakers. This is actually the most difficult part of this entire job because what comes next is a bit of a pain. Pop this plug off its post. However, since an auto shop will jack up their buying price 20% to 40%, you'll pay appreciably more than this, if you have an auto shop replace it. Now if this is your problem I can help,1st.
You will need a 10mm, 14 mm, 17mm, and a 9mm wrench. If you choose to replace it yourself you have to remove the all covers your intake and throttle cable cover. Simply place your Acura's key or anything of a similar shape and width - a feeler gauge will do in a pinch in the slot, and you'll be able to move the shift lever into a … ny desired gear. Excellent fit, secure performance, and robust framework are the major qualities of Bosch's original equipment starter. You will need to move the cruise control module out of the way to get to the starter which is underneath and attached to the engine… Depending on the size of the motor it could be on either side of the truck. This is how they do it at the acura dealership, they just make you wait 2 hours for your car.
Remove the wheels and place a tubing on thebleeder valve with the other end submerged in brake fluid. A service engine light is on, but we had just had the oil changed and they did not shut it off. The starter is just one of many components that reliably at. Then you remove the lower bolt which you get to under the car by the driverside tire the last bolt is in the back by the fire wall facing the oppesset side of the stater they dont tell you that the dealers. I just changed a t-stat in a 96 last night. The lights are on, but nobody's home. With some angling and no brackets holding the back of the starter you should be able to pull it out enough to disconnect the positive wire and 9mm nut from the soleniod.
This is how I did it. To be honest, it is nearly an inevitable problem for most luxury cars. Then remove the electrical connections on the starter, one with a 12mm wrench from under the car, the other is a plug you can reach from the top if your arm is skinny… You can remove the starter from the front of the engine. Once the screws are removed, the speaker grilles can be lifted off from inside the car. Simply remove the speaker grilles. When a car won't start, its owner. Do you have any suggestion what I should do? May 7, 2012 Jul 15, 2011 Aug 25, 2010 Jul 20, 2009 Jan 08, 2016.
Take it to the parts house and match it up with a well made remanufactured or new starter. The only place I have not check is the ignition switch. In addition, we offer stellar customer service and fastest delivery service. The one on my daughters car the housing and the T-stat is located be … hind the throttle bottom. With some angling and no brackets holding the back of the starter you should be able to pull it out enough to disconnect the positive wire and 9mm nut from the soleniod.
Open the hood and work over the engine, not underneath the car. Remove starter, 2 bolts up, may be support on end opposite flywheel. There are 3 bolts holding it on and a wiring harness that has to be disconnected. There are two bolts that will need to be removed which are accessable from the bottom only 15mm. When you remove the T-stat pay attention to the position of the T-stat. That's another 10,000 miles at least you could have driven on them. However, since an auto shop will jack up their buying price 20% to 40%, you'll pay appreciably more than this, if you have an auto shop replace it.
Remove the battery and the battery tray. Then you would want to chock the wheels in the back. You can get a rebuilt starter relatively inexpensively, or get a new one, or rebuild yours. If the vehicle is equipped with a delco loc 2 or theftlock audio system make sure to have the activation code before disconnecting the battery. If yours is 2001 or newer pretty good chance there is none also. At 50,000 miles I would have them inspected. If your car won't start but your battery is good, give your stater a slight, but firm, whack with a hammer.
Both will require removing the Acura plugs. The twin wire connector is positive +. This will expose the tray that it sits on. Disconnect the battery negative terminal. Raise the front of the car and support it securely on… You have to lift the car and look from underneath.